Molded-On Cable Section
UL File E189343

Great Jumper


SRB (Single Row Board)
 Made in Germany
 

Features and Benefits:

• Eliminates usual cable/connector assembling.
• Ultimate strain relief inherent in design.
• Vital one-piece construction eliminates separation problems.
• Inseparable - nothing to come apart.
• No pull tabs required; cable molded into connector.
• Eliminates usually exposed conductor ends.
• Line-by-line probe access holes are standard.
• Single-row contacts on .100 in. (2,54 mm) centers.
• Solders into single rows of PC board holes spaced on standard .100 in. 
  (2,54 mm) centers. Adjacent ends clear when installed end to end. 
  (Jumpers may be placed in continuos-row patterns without loss of holes 
  between connectors).
• Contact length accommodates up to .125 in. (3,18 mm) PC boards.
• Available only as end terminations, not as daisy chains.
• 100% factory testing of each Jumper shipped


SPECIFICATIONS:                                                                                              

Electrical:

Contact material:
Dielectrical withstanding voltage:


1 amp (D.C.)
1000 volts (sea level)


Physical:

Contact material:


CuNi18Zn20 
(see Surface-Finish-Materials Table)


Environmental:

Material:
Operating temperature range:


U.L. rated 94 V-O
-40°C to +105°C


Datasheet: 
 

 

 

 

 

 

 

 

 

 

This  products is listed by Underwriters Laboratories Inc. Representative samples of this product have been evaluated by UL and meet applicable safety standards. UL File E189343.


HOME | ABOUT | PRODUCTS | SOLUTIONS | CONTACT

If you experience any problems please contact webmaster@ap-products.com

Copyright © 1998 by A P Products GmbH - all rights reserved

Last update August 21, 2006